Home
Friction Loss
Schedule 40 Pipe

Type of Pipe:
Pipe Size:
GPM:
Pipe Length:
 
Total Head Lost:
0
Total PSI Lost:
0
Velocity (ft/s):
0

VALUES ARE FOR ESTIMATING PURPOSES ONLY AND MAY NOT MEET HYDRAULIC INSTITUTE STANDARDS
Converter
Head to PSI Converter
Head in Feet:
 
PSI:
0

PSI to Head Converter
PSI:
 
Head in Feet:
0
Wire Size
Wire Selection Guide

Source Voltage:
# of Phases:
Full Load Amps:
Distance (ft):
Voltage Drop:
5%
 
Wire Size:
0

VALUES ARE FOR ESTIMATING PURPOSES ONLY AND MAY NOT MEET NEC CODE
Pump Data
Your Contact Information
Enter your contact information if you plan to submit this data to Munro.
Company:
Address:
City:
State:
Zip:
Contact Person:
Phone:

Pumping Requirements
Enter Gallons Per Minute required by application.
GPM Required:

Elevation
A. Suction Lift
Enter vertical distance, in feet, between the water level and pump inlet.
Total Feet:
B. Elevation Change
Enter the vertical difference, in feet, between the pump inlet and the highest point in the system.
Total Feet:

Friction Loss
Enter total system friction loss. For assistance, refer to Friction Loss Calculator.
Total Feet:
 
Calculator

PSI - Pounds Per Square Inch
Enter the head in feet, converted from psi, required by the largest zone of the system. For assistance, refer to PSI/Head Converter.
Head in Feet:
 
Converter

Total Dynamic Head (TDH)
Press "Calculate" to determine the Total Dynamic Head of this application.
TDH in Feet:
 
Calculate

Electrical
Voltage:
Phase:

Filtration:
Power Supply:

Water
Water Supply:


Back to Top
Contact Us
Phone
Inside Colorado:
800-933-1290
Outside Colorado:
800-942-4270
Web
Email